EPS200

EPS 200 boards bring higher compressive strength than lighter EPS grades, yet remain easy to handle. They are commonly preferred for tougher projects where loads are high, and performance must hold steady.

What Is EPS 200?

EPS 200 is expanded polystyrene rated to achieve 200 kPa at 10% compression. That rating means the board stays firm under stronger floor pressures, with the panels’ tight cell structure improving stability under load.

Builders choose EPS200 when they want insulation that carries weight without losing shape over time. The boards’ thermal performance is efficient, with typical declared values of around 0.033 to 0.034 W/m·K.

What is EPS 200 kPa Used For?

Expanded polystyrene 200 becomes the practical choice for strong insulation and reliable compressive strength. It sits:

• Beneath floors that face constant or heavy applied loads.
• Under commercial slabs, cold stores, industrial walkways, or mezzanine areas.
• Under screeds, concrete toppings, and paved terrace systems.
• Within roof build-ups to enhance thermal insulation and protect against moisture ingress.

Benefits Of Expanded Polystyrene 200

The main advantage of expanded polystyrene 200 kPa is its higher compressive capacity, which allows thinner build-ups without risking performance.

• The panels ensure structural stiffness while maintaining strong thermal values.
•  The panels maintain high compressive resistance while providing reliable thermal performance.
• They are light, making site work easier for teams.
• Many manufacturers also note typically low water uptake and dependable dimensional stability. This combination helps EPS200 handle demanding conditions while staying predictable across the lifespan of the floor.

FAQ

Where to buy EPS 200?

You can buy EPS 200 from Insulation Wholesale. Our UK stock consists of reliable brands, with a range of thicknesses available (25mm, 50mm, 75mm, 100mm, and 150mm). We keep our pricing clear, offer quick quotes, and support bulk orders. Order today and receive a fast quote and kerbside delivery to the site or your home.

How to fix EPS 200

1. Start by cleaning the substrate, as dust can weaken adhesion.
2. Spread adhesive as the datasheet specifies – in ribbons or dabs.
3. Press each board firmly to bed but without applying excessive pressure..
4. Stagger the joints so edges do not line up across rows. Ensure every board sits flat with no rocking or hollow spots.
5. Use mechanical fixings where codes or wind loads require extra restraint.
6. Seal gaps with approved EPS foam or tight board cuts.
7. Tape joints only when the system design requires it.

Always follow the manufacturer’s spacing, curing times, and fixing layout.

How to cut EPS 200

The cutting methods apply to all EPS 200thicknesses. Thicker boards need slower passes and steadier support, where handling may require more care.d. But the tools stay the same.

• Mark your cut line. Use a straight edge and a thick pencil line for visibility.
• Support the board fully. Place it on trestles or a clean flat surface to stop flexing.
• Choose your cutting tool.

1. Fine-tooth handsaw for site cuts.
2. Circular saw with a fine blade for thicker boards.
3. Hot-wire cutter for very clean, factory-grade finishes.

• Start the cut slowly. Begin with a light forward stroke to avoid tearing the edges.
• Keep the blade straight. Guide the tool along the line without forcing it sideways.
• Control your speed. Keep the pressure steady and moderate.
• Clean the edge. Brush away loose beads and check the fit before installing.
• Manage debris and safety. Wear PPE, use extraction where required, and keep the workspace clear.